Flexstar 240V 10ft right-angle M19 power cord

What This Cord Is

This is the OEM-specified 240V power cord for Flexstar commercial LED grow light fixtures that use the M19 3-pin connector standard. The M19 female connector on the fixture end mates directly with the male connector on the Flexstar power supply enclosure — no adapters, no improvising. The right-angle orientation keeps the cord exit profile low and parallel to the fixture body, which matters in tight vertical rack installations where a straight-exit cord would create interference with adjacent tiers or overhead structure.

The 10-foot (approximately 3-meter) run gives sufficient reach from a commercial circuit's whip or PDU to the fixture without adding unnecessary cord length overhead. This cord is sold as a standalone accessory for replacement or for facilities that are adding fixtures to an existing installation and need additional cords sourced separately from the fixtures themselves.

Why Cord Matching Matters in a Commercial Build

Flexstar's own installation documentation is explicit: replace power cords only with original certified cords. Using an uncertified third-party cord on a Flexstar fixture voids the fixture warranty and nullifies compliance with applicable electrical regulations. In a licensed cannabis or hemp facility, that's a compliance exposure you don't need — especially during a state inspection or an insurance audit.

Beyond warranty and compliance, mismatched cords are a real electrical risk. The M19 connector format is specific to commercial horticultural LED fixtures; a cord with the wrong connector body, wrong voltage rating, or incorrect conductor sizing for your circuit's current draw introduces connection integrity problems at the fixture junction. Running 240V commercial LED arrays on undersized or non-OEM cords in a wet or humid grow environment is not an acceptable risk tradeoff. Use the cord the fixture was engineered and certified with.

Voltage and Fixture Compatibility

This cord is rated for 240V service — the standard operating voltage for commercial cannabis and hemp cultivation facilities running Flexstar LED fixtures. Flexstar's commercial PRO-series LED fixtures support multiple input voltages (120V, 208V, 240V, 277V), and the power cord must be matched to the voltage your facility actually delivers to the fixture circuit. If your electrical infrastructure is 240V, this is the correct cord. If your facility runs 208V or 277V, confirm the appropriate cord SKU before ordering.

The M19 connector is the standard power input interface used across Flexstar's commercial fixture lineup. Verify the connector type on your specific fixture's power supply enclosure before placing your order — Flexstar produces fixtures with different input connector standards depending on the series and model year. If you are unsure which cord your fixture requires, have your electrician confirm the connector type or reach out to us with your fixture model number and we will specify the correct cord.

How It Fits a Commercial Installation

In a multi-tier vertical grow rack configuration or a high-density commercial flower room, cord management is infrastructure — not an afterthought. The right-angle M19 connector on this cord allows it to route cleanly along the fixture body and down the rack upright without the connector protruding outward into the aisle or adjacent canopy zone. The 10-foot length accommodates standard ceiling heights and overhead distribution in most commercial build configurations without requiring extension cords, which introduce additional connection points and potential points of failure.

For facilities that are replacing damaged or worn cords on existing Flexstar fixtures, or for electrical contractors sourcing cords for a new fixture installation, this SKU (10-010704-284) is the correct line item for 240V M19 right-angle applications. Order one cord per fixture on 240V circuits, and verify your circuit's whip length against the cord's 10-foot reach before finalizing quantities.