Faven RJ12 to Screw Terminal Adapter

What This Adapter Does

Faven's R-Series under-canopy fixtures (R6, R8, R8 FR) communicate over a standard analog 0-10V dimming signal carried through an RJ12 connector on the power cord communication line. Most Faven-native controllers — the Mini-Controller and compatible third-party units with RJ jacks — plug straight in. But many commercial control panels, lighting controllers, and building-management systems accept only bare-wire screw terminal inputs for their 0-10V dimming channel, with no RJ-style port at all.

This adapter bridges that gap. One end accepts the RJ12 plug from the Faven communication run; the other breaks each conductor out to an individual screw terminal, so you can land the control wires cleanly onto any terminal block. No cutting, no stripping the power cord, no improvised splices — the signal path stays intact and the connection is serviceable.

Who Needs It and When

This part belongs on the spec list any time a commercial facility is integrating Faven R-Series fixtures into a control architecture that does not have a dedicated RJ12 dimming port — common scenarios include Argus, Growlink, or custom BMS panels wired to terminal blocks, multi-zone 0-10V dimmer boards, and retrofit installations where the existing lighting controller was built around screw-terminal inputs.

It is also the correct solution when facilities need to hard-wire a Faven run into a 0-10V control panel to comply with a facility's internal wiring standards — some operations require all low-voltage control wiring to terminate on documented, inspectable terminal blocks rather than modular plugs. Order one adapter per control zone that requires screw-terminal termination. Note: this adapter is designed for the analog 0-10V R-Series (R6, R8, R8 FR) and is not intended for the Faven Chroma line, which uses a separate digital RS485 protocol.

Key Features

The adapter is purpose-built for Faven's communication ecosystem. The RJ12 (6-position, 6-conductor) fixture-side interface mates directly with Faven's watertight communication cables and T-splitters, so it slots into an existing daisy-chain run without disrupting the rest of the network. The screw terminal side provides individual conductor access for a clean, labeled termination at the controller.

Because Faven's R-Series uses the widely adopted 0-10V analog dimming standard — the same protocol used across TrolMaster, Argus, Growlink, and similar platforms — the adapter makes Faven fixtures compatible with virtually any commercial dimming controller that speaks 0-10V, without proprietary hardware in between. The compact form factor means it sits unobtrusively at the point of connection without adding meaningful wire management complexity.

How It Fits a Commercial Lighting Build

In a typical Faven R-Series deployment, fixtures are daisy-chained along a bench run using watertight RJ12 cables and T-splitters. The communication line from the last fixture (or the first, depending on run direction) needs to reach the controller. If the controller has an RJ jack, a standard communication cable does the job. If the controller only has terminal inputs, the RJ12 to Screw Terminal Adapter goes at the end of the run — the RJ12 side connects to the cable coming off the fixture chain, and the screw terminals land on the controller's 0-10V input.

At 120V, Faven supports up to 10 fixtures per circuit; at 240V that extends to 17; at 277V up to 20. In multi-zone facilities where each zone has its own terminal-block dimming channel, one adapter per zone keeps the wiring organized and the control architecture clean. Paired with Faven's watertight T-splitters and communication cables, this adapter completes the accessory set for a fully water-protected, commercially serviceable under-canopy lighting run.