110V Control Board, 6 individual 110V controlled output (1.5A per outlet) for pump control

What the OA6-110 Does

The TrolMaster OA6-110 is a dedicated 110V control board for the Aqua-X Irrigation Control System. Its job is straightforward: take the scheduling and logic outputs from an Aqua-X controller and translate them into clean, individually switched 120VAC power to six separate pump or solenoid valve circuits. Each outlet is rated for a maximum of 1.5 amps, making it well-suited for the small submersible pumps, dosing pumps, and solenoid valves that drive nutrient delivery, recirculation, and drain-to-waste irrigation in commercial cultivation.

The board connects to the Aqua-X via RJ12 cable (a 16-ft cable is included in the box). Double RJ12 sockets on each board allow daisy-chaining so that up to five OA6-110 boards can be connected to a single Aqua-X controller — scaling the system to 30 individually controlled 110V outputs without adding a second controller.

Who This Board Is For

The OA6-110 is the right module for licensed cannabis and hemp operators running the TrolMaster Aqua-X platform who need granular, zone-by-zone pump control across multiple nutrient lines, irrigation zones, or cultivation rooms. A typical commercial use case: a multi-room facility where each zone runs a separate nutrient recipe — the OA6-110 gives the Aqua-X controller a discrete output for each pump feeding each zone, fully governed by the controller's schedule or recycle-timer logic.

It's also well-matched for operations adding canopy or reconfiguring rooms mid-build. Because boards daisy-chain in series via RJ12, adding irrigation zones means adding another OA6-110, not replacing the controller. Facilities that grow a zone at a time benefit from this incremental expansion path.

Key Features

Individual outlet control: all six channels are switched independently, so any combination of pumps can be active at the same time. Each outlet has its own LED indicator that shows on/off status at a glance — useful when commissioning a system or diagnosing a delivery issue without pulling up a software interface.

An addressing button on the board lets the Aqua-X identify each module uniquely within the daisy chain, which is necessary when multiple OA6-110s are connected in series. The RJ12 daisy-chain architecture keeps wiring clean and the installation straightforward — no separate communication hub or proprietary wiring harness required beyond the included cable.

The board's working environment spec — 32°F to 122°F with humidity up to 90% — covers the temperature and humidity range of most commercial grow rooms, including high-humidity propagation and veg environments.

How It Fits a Commercial Irrigation Build

In a commercial Aqua-X build, the OA6-110 typically sits at the end of the control chain: the Aqua-X controller handles the schedule, sensor inputs, and recycle logic, and the OA6-110 executes the switching at the pump level. For operations running both schedule-based and recycle-based watering plans simultaneously across different zones, this separation of logic from switching is what makes multi-zone automation practical.

With five boards daisy-chained, an Aqua-X system can independently address 30 pumps or solenoid valves — enough output density for a large multi-room or multi-tier cultivation facility without a secondary controller. Facilities planning a phased expansion can start with a single OA6-110 (six zones) and add boards incrementally as new rooms or benches come online, keeping up-front infrastructure cost proportional to actual canopy.